clish
add dhcp server subnet <network-ip> netmask <cidr>
add dhcp server subnet <network-ip> include-ip-pool start <pool-start-ip> end <pool-end-ip>
set dhcp server subnet <network-ip> include-ip-pool <pool-start-ip>-<pool-end-ip> enable
set dhcp server subnet <network-ip> default-lease <default-lease-time>
set dhcp server subnet <network-ip> max-lease <max-lease-time>
set dhcp server subnet <network-ip> default-gateway <default-gw-ip>
set dhcp server subnet <network-ip> dns ‘<server1>, <server2>’
set dhcp server subnet <network-ip> domain <domain>
set dhcp server subnet <network-ip> enable
set dhcp server enable
save config

Documentation

[ # ]

cphaconf set_ccp multicast   !! Use Multicast (default mode, most efficient)
cphaconf set_ccp broadcast   !! Use Unicast

cphaprob -a if    !! Verify current mode and monitored interfaces

Documentation

[ # ]

clish -s -c "set static-route <ip>/<cidr> nexthop gateway address <gateway> on"
clish -s -c "set static-route default nexthop gateway address <gateway> on"

[ # ]

clish 
add user <username> uid <uid#> homedir /var/<username>
set user <username> shell /bin/csh
add rba user <username> role monitorRole
save config

Notes:

  • UID should be above 120. If you give a UID of 0, that will give the user read/write access
  • The 'RBA' line assigns the default readonly Voyager role, monitorRole, to the user. If the user does not need Voyager access, this can be ignored.

[ # ]

chsh -s /bin/bash <username>

[ # ]

ethtool -s <interface> speed <speed ie 100> duplex <duplex> autoneg off  !! Modify interface speed

config conn set local <ip>/<cidr> name <interface>  !! IP an interface
config conn add type vlan local <ip>/<cdir> vlan-tag <vlan-tag> dev <physical-int-name>  !! Create sub-interface with vlan
config conn del name <vlan-int>  !! Delete sub-interface

!! Configure monitoring of interface for failover (add/delete required interfaces, 1 per line)
cpstop
vi $FWDIR/conf/discntd.if
cpstart

[ # ]

cphaprob stat  !! view failover status
cphaprob -a if  !! view interface VIP configuration

[ # ]

fwha_vmac_global_param_enabled 1        !! Enable Until Reboot
fwha_vmac_global_param_enabled 0        !! Disable (default)

vi $FWDIR/boot/modules/fwkern.conf        !! Enable Permanently
fwha_vmac_global_param_enabled=1

Notes:

  • This is useful so that the MAC addresses of the VIPs do not change on failover of a cluster. This may correct issues with switches holding onto the old VIP MAC address.

Documentation

[ # ]

webui enable <port>
webui disable

Documentation

[ # ]

useradd -u 0 -g 0 -o -s /bin/bash <username>

[ # ]